Qlima LK 3006 Manuel D'utilisation page 51

man_LK3006 ('21) V3.indd 51 man_LK3006 ('21) V3.indd 51
CAUTION
1. Use normal power supply.
2. Do not place objects on the top of the unit. Do not cover the air outlet when
in use and obstructed of front and back in one meter.
3. After filling with water, do not tilt or collide the unit, when you need to
move the unit, push the side surface slowly so as to avoid water splashing
out. Do not overturn the unit in service to prevent accident (F.4).
4. The body of the unit may not be place in area with extremely high or low tem-
perature. In hot summer, the water in its water tank is liable to deterioration
with odor and should be changed frequently. In winter, at room temperature
lower than 0 degree, it is necessary to remove the water and clean with dry
towel to avoid frost.
5. In cleaning the outer surface of the unit, wet cloth (or with some detergent)
should be used. Do not use any corrosive cleaner or solvent for this purpose.
Rinsing with water is absolutely not allowed. (F.5)
6. If packed for storage or transportation, please drain the water and make the
unit working a few minutes, after totally dry then pack it, in order to avoid
the peculiar smell.
7. Don't keep the plug connecting when long time no using the unit, it will be
damaged.
8. If the supply cord is damaged, it must be replaced by the manufacture or its
service agent or a similarly qualified person in order to avoid a hazard.
9. The unit has strong humidity effect, please shut this function in the airtight
environment.
10. Filling water when it is in the low water level.
11. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
se of the appliance by a person responsible for their safety.
12. Children should be supervised to ensure that they do not play with the
appliance.
TROUBLESHOOTING
Problem Cause
No air flow 1. Power is not connected.
2. Power is not turned ON.
3. Body damaged.
Fail to shutdown the Fan 1. Stop key has not been pressed
yet.
2. Body damaged.
Abnormal sound from 1. Foreign article inside the body.
Product body 2. Loose air wheel.
3. Motor defect.
No damping 1. Defective pump or motor.
Air flow direction can not 1. Defective front synchronization
be controlled motor.
Solution
1. Plug the power cable properly.
2. Press the power key to start.
3. Return to Service Center.
1. Press key Start/Stop.
2. Return to Service Center.
1. Remove rear cover and strainer,
remove foreign articles.
2. Return to Service Center.
3. Return to Service Center.
1. Return to Service Center.
1. Return to Service Center.
4
51
22-12-2021 12:20 22-12-2021 12:20