Publicité
Les langues disponibles
Les langues disponibles
SuperLine In sta ll a tio n
3 Super Line Inst a lla t io n
The SuperLine moving coil phono amplifier is designed to extract the best possible musical
performance from vinyl disc replay. It should be mounted horizontally on an equipment
stand intended for the purpose. It is important to ensure that it is level.
The SuperLine contains no internal power supply and must be connected either to a Naim
amplifier incorporating an appropriate power supply output, or to a dedicated Naim
power supply. SuperLine output is muted for 2 minutes following switch-on to allow its
circuitry to reach optimal status.
Cartridge loading resistance and capacitance can be adjusted by inserting combinations
of resistive and capacitive "load plugs" into sockets on the SuperLine rear panel.
The SuperLine incorporates a suspension system to isolate its sensitive components from
vibrational energy. The suspension system is protected during shipping by two transit
screws. The transit screws must be removed before use. Once the transit screws are
removed the SuperLine must not be inverted. Transit screw removal is best carried out
once the SuperLine is installed in its final location and all connections are made.
3. 1 Tra nsit S cre ws
Two transit screws must be removed from the underside of
the SuperLine before use and replaced if it is to be carried
any distance, packed or shipped. Transit screw removal is
illustrated in Diagram 3.2. SuperLine transit screws must not
be used with any other Naim product.
Damage may result if the SuperLine is inverted either
during or after transit screw removal.
To gain access to the transit screws, position one end
of the SuperLine over the edge of a table, remove (or
replace) the screw that becomes accessible and then
repeat with the other end.
3. 2 Tra nsit S cre w Re mo v a l
front transit
screw
rear transit
screw
3 . 3 C o n n e c ti n g Su p e r L i n e
3.3.1 Power Supply
The SuperLine must be connected to a dedicated
Supercap, Hi-Cap or Flatcap power supply (option
one) or a Naim preamplifier or integrated amplifier that
incorporates an appropriate power supply output (option
two).
If option one is chosen, connect the SuperLine to the
dedicated power supply using, in the case of a Hi-Cap
or Flatcap, a Naim SNAIC interconnect cable, and in the
case of a Supercap, the appropriate Naim Burndy cable.
In either case take care to connect with the correct cable
orientation.
If option two is chosen, connect the SuperLine to the
preamplifier or integrated amplifier's 5 pin DIN aux input/
power output socket using a Naim SNAIC interconnect
cable. Take care to connect with the correct cable
orientation.
Note:
If the SuperLine's Burndy power supply socket is
not used the supplied Burndy link plug must be inserted.
Similarly, if the SuperLine's DIN power supply socket is not
used the supplied dust cover should be fitted.
3.3.2 Signal Input
Connect the output cable of the pick-up arm to either
the BNC or phono input sockets. Only one option, phono
or BNC, should be connected at any time. Take care to
ensure that the left and right channels are connected to
the appropriate sockets.
Connect the pick-up arm earth lead to the rear panel
ground
terminal.
3.3.3 Signal Output
The SuperLine output signal is carried on the power supply
cable either directly to the preamplifier or via an optional
power supply.
1
Publicité
