Wall Installation (With Fixing Bracket) - Panasonic WX-SA250P Mode D'emploi

Installation

■ Wall installation (with fixing bracket)

Unplug all cables from the antenna and follow these installation procedures.
⿟ When installing the antenna on a wall, place it higher than 1.5 m (59-
Important
1/16 inches) from the floor. Placing the antenna at a low place could
reduce the range it can cover. In particular, people, metal products, and
pieces of furniture placed between the antenna and the microphone may
block the radio waves interfering with the transmission, resulting in audio
dropouts.
1
Screw the fixing bracket to the wall
Fix the fixing bracket to the wall with the four included wood screws (4.1 mm x 25 mm
(3/16 inches x 1 inches)).
Pay attention to the direction into which the arrow ( ) is pointing relative to the fixing
bracket. The arrow ( ) reflects where the top of the antenna will point.
Fixing bracket
(included)
⿟ The minimum pullout strength required for each wood screw is
Important 196 N.
⿟ Do not install the antenna on gypsum boards, plywood, or walls
made of other fragile materials. If you absolutely must do so, make
sure that the wall is reinforced enough.
⿟ For fixing the bracket, only use the screws included with the
antenna. Not doing so may cause the antenna to fall.
20
Mind the direction
Wood screws
(included)