Panasonic WX-SA250P Mode D'emploi page 13

A Power indicator [POWER]
Shows the operation status of the antenna
On (green):
Blinking (orange): Pairing
Blinking (red):
On (red):
Off:
Important
Alternately blinking (orange/green):
⿟ When a receiver is in pairing mode, the [POWER] indicator on all the
antennas connected to it will blink orange. Refer to the microphone
manual and the wireless receiver manual for further details on pairing
devices.
B Screw cover
Used to install the antenna on the ceiling or on a wall. Open this screw cover and tighten
the screw inside it to fix the antenna to the fixing bracket.
C Hook grooves
Used to install the antenna on the ceiling or on a wall. Attach these grooves to the hooks
on the fixing bracket.
D Cable routing groove
Pass the LAN cable (page 16) through this groove to fix it into place.
E Cable tie hook
Pass the included cable tie through this hook to secure the cable.
F Connector cover
When installing the antenna open this cover, connect the cable to the wireless receiver
connector, then close the cover.
G Stand attachment hole cover
Used to install the antenna on a microphone stand.
H Wireless receiver connector (inside the port cover)
Used to connect the antenna to either a receiver. Use a LAN cable for the connection.
Powered
Connection error with the receiver
Communication error with the receiver
Not receiving power from either the receiver
Antenna newly connected after powering ON the receiver
T he support software on the PC connected with the receiver is
performing a check
13