Replacement Parts; Battery Replacement; Assembly Procedure For Seals; Technical Service - CH CHN70600 Instructions D'utilisation Et Manuel De Pièces

Cloueuse à angle pour finition
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operating Instructions and Parts Manual
Maintenance (Continued)

rePlACeMeNt PArts

Use only genuine Campbell Hausfeld service parts. Tool performance,
safety and durability could be reduced if improper parts are used. When
ordering replacement parts, specify by part number.

BAttery rePlACeMeNt

Always disconnect the tool from the power source when unattended,
performing any maintenance or repair, clearing a jam, loading,
unloading , or moving the tool to a new location.
The electronics on the tool (low nail indicator lights and nail placement laser pointer)
run off of two (2) AAA batteries located in the compartment on the back of the
magazine. When the batteries' power is running low and they need to be replaced,
the electronic functions may not work properly or at all. Disconnect the tool from air
source and remove the battery compartment cover by pulling out. Insert two (2) new
batteries in the proper orientation. Do not mix old and new batteries. Close cover.

AsseMBly ProCedure For seAls

When repairing a nailer, the internal parts must be cleaned and lubricated. Parker O-
lube or equivalent must be used on all o-rings. Each o-ring must be coated with O-lube
before assembling. A small amount of oil must be used on all moving surfaces and
pivots.

teCHNICAl servICe

For information regarding the operation or repair of this product, please call 1-800-
543-6400.

FAsteNer INterCHANge INForMAtIoN

Fasteners used in the Campbell Hausfeld CHN70600 Angle Finish Nailer will also work
in the following brand units:
Bostitch T31-1, T29-30, BT-35, BT50
Duofast BB4440
Hitachi NT45A
Paslode 2138-F40
Porter Cable BN125, BN200
Sears 18409, 18424
Senco SLP20, LS2, LS5.

FAsteNers

The following Campbell Hausfeld brad nails are available at local retail stores. For help locating any item,
call customer service at 1-800-543-6400. Campbell Hausfeld nails meet or exceed ASTM Standard F1667.
Model #
Length
FB153599AV
1-1/2 inch
(Multi-pack)
2 inch
2-1/2 inch
16
www.chpower.com
Shank Gauge
Finish
15 Gauge
Coated
15 Gauge
Coated
15 Gauge
Coated
Head
Collation
D Clipped
Mylar Tape 35°
D Clipped
Mylar Tape 35°
D Clipped
Mylar Tape 35°
Figure 25 - Battery replacement
Nails Per Stick
Nails Per Box
50
50
50
CHN70600
500
500
1000

Publicité

Table des Matières
loading

Table des Matières