Publicité
Les langues disponibles
Les langues disponibles
to the desired position and then tightening the
knob.
Figure 6
G. HEATED NIP ROLLERS: (figure 6) Heats the film to
activate the adhesive and provides pressure to
ensure film adheres to the media.
.
H. IDLER BARS: (figure 6) The Idler Bars, located near
each supply roll, are used to direct the film to the
NIP ROLLERS. The lower Idler Bar is attached to the
Feed Table to facilitate easy film loading.
I.
PULL ROLLERS: The Pull Rollers are located at the
back of the laminator. They simultaneously pull the
film through the laminator and provide tension as
the film cools to ensure quality lamination.
Figure 7
J.
REAR SLITTER: (figure 7) Used to cut the film when
it exits the rear of the laminator.
K. Circuit Breaker: (figure 2) The circuit breaker is
located below the power cord and can be reset by
pushing the button. If the circuit continues to fail,
please contact authorized service provider.
L.
AUTO SHUT-OFF: After two hours of inactivity the
laminator will go into Standby mode reducing heat
and appearing to be shut down. After three hours
of inactivity the machine will shut down. To activate
the laminator, ensure the Main Power button is in
the ON position ('I ') and press the ON/OFF button
on the front of the machine.
Figure 8
M. FILM ROLL
SUPPLY: The Pinnacle 27 uses standard
rolls of film while the Pinnacle 27 EZload uses EZ
Load laminating film (figure 8).
Figure 9
N. FILM SADDLES:
EZLoad film supply is loaded into
the saddles on the Pinnacle 27EZload (figure
Figure 10
O. AutoGrip FILM SHAFT: The Film Shaft is used for
loading standard film onto the Pinnacle 27
Laminator. (Figure 10)
Figure 11
P. FILM BRACKET AND HOLDER: Film shaft is loaded
into the holder (figure 10a) and bracket (figure
11b).
9).
Publicité
