Makita DMP181 Manuel D'instructions page 11

Using the Presta valve adapter
1. Loosen the locking nut on the valve stem.
► Fig.12: 1. Locking nut
2. Attach the Presta valve adapter to the valve
stem, and then attach the air chuck to the Presta valve
adapter.
► Fig.13: 1. Presta valve adapter 2. Valve stem 3. Air
chuck
3. Turn on the tool, and then set the pressure value
appropriate for the tire using the pressure gauge.
4. Keep pulling the switch trigger until the tool stops.
The tire is inflated with the specified pressure.
5.
Remove the air chuck and Presta valve adapter,
and then tighten the locking nut.
Using the sport ball needle
NOTICE:
Be sure to select the ball mode when
you inflate a ball using a sport ball needle. If other
mode is selected, the inflation cannot be performed
properly.
To inflate sport balls, use the sport ball needle.
1. Attach the sport ball needle to the air chuck.
► Fig.14: 1. Air chuck 2. Sport ball needle
2. Insert the sport ball needle into the hole on the
ball.
3. Turn on the tool.
4.
Set the inflation mode to the ball mode, and set
the pressure value appropriate for the ball using the
pressure gauge.
5. Keep pulling the switch trigger until the tool stops.
The ball is inflated with the specified pressure.
Using the tapered adapter
CAUTION:
Be careful not to inflate the float-
ing tube too much.
To inflate floating tubes, use the tapered adapter.
1. Attach the tapered adapter to the air chuck.
► Fig.15: 1. Air chuck 2. Tapered adapter
2. Insert the tapered adapter into the hole on the
floating tube.
3.
Turn on the tool.
4.
Inflate the floating tube by pulling the switch trig-
ger while checking the status of the floating tube.
NOTICE:
When inflating a floating tube, do
not refer to the current pressure value on the
pressure gauge. The pressure gauge does not
display an accurate current pressure value when
the pressure of floating tube is less than 35 kPa
(5 PSI).
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Makita genuine battery and charger
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
11 ENGLISH