charcoal filter saturation indicator light is usually
deactivated.
If no control is given within maximum 10 sec, the hood
automatically exits this function, at any time, and returns
to the previous state.
Press and hold the B+C keys (Simultaneously) to enter
the setup menu:
Briefly press button C to select the filter to be set up:
Grease filter:Green
Charcoal filter: Red
Briefly press button B to activate (the 2nd LED flashing)
or deactivate (2nd LED off).
Note: the LEDs light up for a limited number of seconds
after which they turn off to indicate that the indicator light
has been activated (or deactivated).
The device can also be used in combination with a
Window sensor KIT (not supplied by the manufacturer).
If the Window sensor KIT is installed (only in the case of use
in EXTRACTOR mode), air extraction will halt every time the
window in the room, on which the KIT is applied, is closed.
-
The KIT must be electrically connected to the device
by qualified and specialised technical personnel.
-
The KIT must be certified separately in accordance
with the safety standards for the component and its
use with the device. Installation must be carried out
in accordance with current regulations for domestic
systems.
PLEASE NOTE:
-
the wiring of the KIT to be connected to the device
must be part of a certified safety extra-low voltage
(SELV) circuit.
-
the manufacturer of this device declines all liability
for any inconvenience, damage or fires caused by
defects and/or problems associated with the
malfunction and/or incorrect installation of the KIT.
Maintenance
Cleaning
Clean using ONLY a cloth dampened with neutral liquid
detergent.
DO
NOT
INSTRUMENTS. Do not use abrasive products. DO NOT USE
ALCOHOL!
Panel
Fig. 9
The panel for perimeter suction should always be left closed
and should only be opened in case of maintenance
interventions (eg cleaning or replacing filters).
Grease filter
Fig. 9
Traps cooking grease particles.
This must be cleaned once a month (or when the filter
saturation indication system – if envisaged on the model in
possession – indicates this necessity) using non aggressive
detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolor
slightly, but this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle.
Replacing lamps
The hood is equipped with a lighting system based on LED
technology.
The LEDs guarantee an optimum lighting, a duration up to 10
times longer than the traditional lamps and allow to save 90%
electrical energy.
For replacement, contact the technical service.
20
CLEAN
WITH
TOOLS
OR