Fagor BMF-200X Manuel D'utilisation page 7

2. Remove the upper cover on the top of
the refrigerator starting from the right
side and then remove the upper cover of
the upper door.
1
Then remove the corner cover and the
upper hinge cover. Put all parts into the
plastic parts bag.
2
3. Disconnect reed switches shown in
images 1 and 2. Remove cover on the
cabinet body shown in image 3.
Door racks
①Upper cover
②Upper hinge cover (right)
③Upper cover of upper door
④Corner cover
3
1
2
3
4. Remove the special fl ange self-tapping
screws indicated in the image below and
the upper hinge below. Unplug the earth
wire indicated below.
①
Special flange self-tapping
screws
②
Ea rth wire
Note: Please hold the upper door by hand
during step 4 to prevent door from dropping.
5. Remove the upper door by lifting
vertically and place it on a smooth
surface with the panel facing upwards.
1
Remove the handle covers and screw
hole covers, then remove special self
tapping screws. Remove the handle and
switch it to the right side, then install the
self-tapping screws, handle covers and
screw hole covers in reverse order from
which they were removed.
2
3
Loosen the self-tapping screws, detach
the stop block and door holder. With the
handle in place, reinstall the door holder
and the spare stop block found in the
plastic bag. Do not use the one you just
removed, that one must be stored in the
plastic parts bag.
1
7
③
upper
hinge
① Handle covers
② Special self-tapping screws
③ Handle
④ Screw hole covers
⑤ Door holder
⑥ Stop block
⑦ Self-tapping screws
2