Installation Options; Outside Pole Mount (Best Option) - weBoost Home 3G Mode D'emploi

8. Connect the Home 3G to a surge
protected AC power strip with at least a
1000 Joule rating. If your Home 3G is
working correctly, the lights will be green.
If the lights are orange or red, see
the "Troubleshooting" section on
page 9.
NOTE:
Modern energy efficient dual-
pane windows with coatings will
weaken the cellular signals as
they pass through because of a
metal oxide film applied during
manufacturing. If you have dual-
pane windows with energy efficient
coatings, we recommend one
of the other mounting options if
your performance is not to your
satisfaction.
6
Need help?

Installation Options

Outside Pole Mount
(Best Option)
1.
2.
3.
4.
www.weboost.com
Select a location on the roof where the
Outside Antenna can be mounted on
a pole maintaining at least 20 feet of
vertical or horizontal separation from the
inside Desktop Antenna.
Place the desktop signal
antenna directly beneath the
placement of the Outside
Antenna location
At least 20 feet of vertical
or horizontal separation
from the desktop antenna
is needed
Find an existing pole or obtain a
pole of 1 to 2 inches in diameter.
Mounting hardware to attach the pole
to the roof can be purchased from a
hardware store or you can purchase a
weBoost's pole mount accessory kit,
part #901117. Install the pole in the
desired location.
Using the hardware in Packet A,
insert the U-bolt through the holes in
the Outside Antenna. Slide one half of
the bracket assembly onto the U-bolt.
Fit the assembly onto the pole in your
desired location by sliding the second
half of the bracket onto the U-bolt and
securing it with the lock washers and
nuts provided. Be sure the cradle is at
the desired height and rotated toward
the strongest cellular signal before
tightening the nuts. Do not over tighten.
Customer Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
Rotate in small
increments