Ecler IC6CLASSTR Notice D'utilisation page 5

NOTE: In most cases, the electro-acoustical response of a ceiling/wall speaker like the
IC6CLASS-TR will be better if it is installed in a ceiling or on a wall made of low-porosity
materials and without the rear cover. The response in the low frequency range will be especially
affected, since these types of ceilings act as baffles" or mechanical loudspeaker enclosures.
5. Using a flat screwdriver, set one of the following taps with the power selector on the front of the
speaker:
Tap #1
Tap #2
Tap #3
Tap #4
Tap #5
Tap #6
6. Test the operation by powering up the sound system.
7. Finally, install the grill on the speaker frame and turn it slightly so that the revolving fasteners of
the frame and the grille are fitted together. During assembly, hold the grate by the edges (not
the perforated, centre part) to avoid damaging it.
5. PAINT
IC6CLASS-TR is ready to be painted and thus can match any cosmetic criteria of the
environment in which it is installed.
Once the installation is complete, the front grill is the only visible part of the unit, simply paint it
to get the desired result. Paint it carefully, avoiding excess paint from clogging the small holes in its
central area.
Connection to a 70V line
16 Ω - 75 W
1,5 W
3,7 W
7,5 W
10 W
15 W
Connection to a 100V line
16 Ω - 75W
3 W
7,5 W
15 W
20 W
30 W
5