Télécharger Imprimer la page

Ega Master AQUAMaster Manuel D'instructions page 28

Publicité

Les langues disponibles

Les langues disponibles

When working on or with the equipment, it is imperative to observe all requirements in regards to
waste- disposal and proper recycling.
In particular during installation, repair and maintenance work, water damaging agents, such as
lubricating grease and oil,
hydraulic fluid,
coolant,
solvent containing cleaning agents
must not leak into the ground or reach the sewage system.
These materials must be stored, transported, contained and disposed of in suitable containers!
Unused machines and machine tools should be kept in a dry, closed room. Keep them free from damaging
influences such as damp, frost or large temperature fluctuations as well as mechanical damage.
Worn/ defect machine tools must be disposed of according to regional/ national specifications. Fully disassemble
machine for the necessary disposal.
Separate materials according to local environmental specifications.
To avoid environmental damage, hazardous material like lubricating, cooling and cleaning agents have to
disposed appropriately.
In case of disturbances check, if all instructions contained in this technical documentation are adhered to and
make the appropriate adjustment, if needed.
The following table shows possible problems and causes:
a
b
c
d
e
If necessary, send the machine to the manufacturer.
28
ENVIRONMENTAL REGULATIONS
STORAGE
DISPOSAL
TROUBLESHOOTING
Problem
Machine does not start
Valve lever/ pin jams
Machine turns too slowly
Motor jams
Maschine makes strong
noise
Cause
not connected to hydraulic
supply
Valve not actuated
Impurities in the valve
operation pressure too low
adjustment device jams
bearing friction in the
gearbox
coarse dirt in the engine
bay
breakage of motor parts
friction bearing defective
gear tooth system too loose
Remedy
Connecting and opening of
the hydraulic line
actuate valve
disassemble valve parts
and clean
increase operation
pressure at the machine
disassemble motor, clean,
replace worn parts
disassemble gear, clean,
replace worn parts
Disassemble motor, clean
replace worn parts
disassemble machine,
clean, replace worn/
damaged parts, optimize
gear tooth system

Publicité

loading

Produits Connexes pour Ega Master AQUAMaster

Ce manuel est également adapté pour:

79921