Publicité
Les langues disponibles
Les langues disponibles
A malfunction, which impairs operator safety, must be immediately removed.
Pay attention that the machine is cleaned from dust and deposits of rust particles and other deposits before and
after the work.
SAFETY INSTRUCTIONS FOR PREVENTION OF WORKPLACE HAZARDS
WARNING - The following applies unless otherwise stated in the machine's operating
instructions booklet:
The machine is not insulated to protect against an electrical power surge.
CAUTION – risk of injury! - Hands may be crushed, seized or otherwise injured.
Keep your hands away from areas which are marked with this symbol.
Caution – risk of injury! - Remove all sources of danger which could lead to slipping,
tripping or falling (e.g. slippery surface, hoses, cables).
Keep the work area clean and dry.
PROHIBITION - Eating, drinking and smoking are forbidden during operation.
ATTENTION – risk of explosion! - Operate the machine according to the intended use only.
The machine is not applicative in explosive atmospheres. Consider the following:
• The generation of sparks is typical for grinding work.
• Nearby workplaces should always be protected against flying sparks, e. g. partitions or
curtains.
• Flammable and explosive material has to be removed from the work area before work is
started.
•
Among others, this relates to dust deposits, cardboard, packing material, textile, wood and wooden splints,
but also flammable fluids and gas.
Make sure there is adequate lighting.
Be extra careful in unfamiliar surroundings. There is a risk of hidden hazards such as electric lines or other supply
lines.
Make sure when operating the machine that no electrical cables, gas pipes or similar could be damaged.
Use suitable and personal protective equipment.
SAFETY INSTRUCTIONS FOR PREVENTION OF HAZARDS CAUSED BY HYDRAULIC
WARNING - Hydraulic can cause severe injury.
Before working on the tools (e.g. installation, changing accessories or machine tools, prior to a
long standstill, maintenance, etc.) disconnect equipment from hydraulic supply (close stop valve).
WARNING - Risk of injury by a whipping hydraulic hose.
Check hydraulic hoses, connection components and fittings regularly for any damages and proper fixture.
When connecting/ disconnecting the machine to / from the hydraulic supply, please pay careful attention not to
actuate the start lever while doing so. Never remove a pressurized hydraulic hose.
Always switch the power supply off first and then depressurize the machine by pressing the valve latch. The
maximum operation pressure according to the technical specification must not be exceeded. A pressure regulator
22
Publicité
