skilsaw SPT67WMB Consignes De Fonctionnement/Sécurité page 10

SM 1619X09467_SPT67WMB 11/17/15 9:33 AM Page 10
Disconnect plug from power source. Loosen
the depth adjustment lever located between
the guard and handle of saw. Hold the foot
down with one hand and raise or lower saw by
the handle. Tighten lever at the depth setting
desired. Check desired depth (Fig. 3).
FIG. 3
90° CUTTING ANGLE CHECK
Disconnect plug from power source. Set foot to
maximum depth of cut setting. Loosen bevel
adjustment lever, set to 0° on graduated
quadrant, retighten lever and check for 90°
angle between the blade and bottom plane of
foot with a square. Make adjustments by turning
the small adjustment screw from the bottom
side of foot, if necessary (Fig 5).
BEVEL ADJUSTMENT
Disconnect plug from power source. The foot
can be adjusted up to 45° by loosening the
bevel adjustment lever at the front of the saw.
Align to desired angle on the graduated
quadrant. To adjust beyond 45°, depress 45°
stop spring (Fig. 6), align foot to desired mark
over 45° on quadrant and tighten lever.
Because of the increased
amount
WARNING
engagement in the work and decreased
stability of the foot, blade binding may
occur. Keep the saw steady and the foot
firmly on the workpiece.
Operating Instructions
DEPTH ADJUSTMENT
Not more than one tooth length of the blade
should extend below the material to be cut, for
minimum splintering (Fig. 4).
DEPTH SCALE
Calibrated For
Standard Lumber
Sizes
DEPTH
ADJUSTMENT
LEVER
BLADE WRENCH
& STORAGE
AREA
FIG. 5
FOOT
BLADE
FIG. 6
of blade
-10-
ONE TOOTH LENGTH SHOULD
PENETRATE WOOD FOR
MINIMUM SPLINTERING
GRADUATED
QUADRANT
90°
ALIGNMENT
BEVEL 45°
ADJUSTMENT SPRING
LEVER STOP
FIG. 4
BEVEL
ADJUSTMENT
LEVER
SCREW
GRADUATED
QUADRANT