Tripp-Lite SmartOnline SU3000RTXL2U Manuel Du Propriétaire page 11

3. Operation
3.4 Rear Panel
NEMA L5-30P
NEMA L5-30R
NEMA 5-15/20R
201102140 932835.indb 11
( continued )
Accessory Card Slot: Remove the cover panel from this slot to install an
optional internal SNMPWEBCARD or RELAYIOCARD accessory, sold
separately. SNMPWEBCARD provides a network interface for monitoring
and control via SNMP, Web or telnet, enabling remote reboots, shutdowns
and more. RELAYIOCARD provides a programmable contact closure
interface with 6 outputs and 1 input.
External Battery Pack Connector (Configuration Varies By Model)
Fan: The fan cools the UPS system's internal components. It is always on
when line power is present, even if power to the UPS system's outlets is
turned off.
Output Circuit Breakers (Select Models Only): These resettable circuit
breakers protect the UPS system from output overload. If a breaker trips,
remove some of the load on the circuit and allow the UPS system to cool
before pressing the breaker button to reset.
Input Power Cord: This permanently attached power cord connects the UPS
system to a compatible power outlet.
AC Outlets (Configuration Varies By Model): These outlets provide
connected equipment with pure sine wave AC output derived from the AC
line during normal operation and derived from battery power during blackouts
and severe brownouts or overvoltages. Output power is filtered to protect
connected equipment against damaging surges and line noise.
The outlets are divided into numbered load banks, as labelled on the unit.
Using included PowerAlert software and cabling or an optional
SNMPWEBCARD, load banks may be individually turned off and on from a
remote location, allowing users to reset or reboot connected equipment.
11
CONTROLLABLE LOAD 1
CONTROLLABLE LOAD 2
3/29/2011 4:50:21 PM