maintenance
EN
6.7
care of glass
WARNING
!
•
Do not clean glass when hot! Do not use abrasive cleaners to clean glass.
If the glass is not kept clean, permanent discolouration and/or
blemishes may result. Normally a hot fi re will clean the glass. The
most common reasons for dirty glass include:
•
Not using suffi cient fuel to get the appliance thoroughly hot.
•
Using green or wet wood.
•
Closing the draft so far that there is insuffi cient air for complete
combustion.
If it is necessary to clean the glass, buff lightly with a clean dry cloth and non-abrasive cleaner. Clean the glass
after the fi rst 10 hours of operation with a recommended appliance glass cleaner. Thereafter, clean as required.
The glass is very strong, but do not let burning fuel rest or fall against it and always close the door gently.
NEVER FORCE OR SLAM IT SHUT!
Do not operate the appliance with broken glass, as leakage of fl ue gases may result.
Contact your local authorized dealer/distributor for complete cleaning instructions.
If the glass should ever crack or break while the fi re is burning, do not open the door until the fi re is out. Do not
operate the appliance until the glass has been replaced. Contact your local authorized dealer/distributor for
replacement parts. DO NOT SUBSTITUTE MATERIALS.
6.8
blower service or replacement
A.
Turn off all electrical power to the
appliance.
B.
Remove the two screws securing the
cover to the blower housing.
C.
Remove ground wire screw.
D.
Remove the four screws securing the
retainer and lift the retainer/blowers up
and out of the housing.
E.
Dust and debris may accumulate,
vacuum the blowers and housing prior to
re-installation.
F.
If blower replacement is required, each
blower is attached to the retainer by four
screws. Remove the screws to replace
or repair.
G.
Re-install by reversing the procedure.
26
W415-2799 / B / 03.10.20
!
COVER
RETAINER
GROUND
WIRE
WARNING
HOT GLASS WILL CAUSE
BURNS.
DO NOT TOUCH GLASS UNTIL
COOLED.
NEVER ALLOW CHILDREN TO
TOUCH GLASS.