Publicité
Les langues disponibles
Les langues disponibles
4
c.
Tap on the Kinex Salt Monitor Tile.
d.
Press and hold the Wi-Fi reset button on the side of
the monitor until the LED light turns solid purple upon
completion of the Wi-Fi reset. It will remain purple
for 5 seconds and then turn solid red for 5 seconds.
Finally, when the device is in AP mode the LED will
blink purple. Tap "Connect." This process removes any
previous Wi-Fi credentials and puts the salt monitor
device into connection mode.
Note: For best results with Wi-Fi pairing, remove the
salt drum lid with the monitor installed and position it
near the router for steps 3d-3h. After the connection
is established (blue light), replace the lid on the drum.
Press the reset button one time. LED light will change
colors as the device attempts to reconnect. Verify that
the final LED color is blue when in its final installation
location.
e.
Now that the device has been located and put into
connection mode, the device must be connected to
the home Wi-Fi network. Tap "Join."
Publicité
