AUTO-HAK G39A Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
A
6
5
7
11
12
10
B
9
This towbar is designed to assembly in following cars:
RENAULT LAGUNA 5 doors, produced since 2001 till 2007, catalogue
no.G39A and is prepared to tow trailers max total weight 1500 kg and max
vertical load 75 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
12
7
A
11
1
13
23
3
From manufacturer
1. Underside the car (in the rear panel) find plugged holes on the right and
left side, then make them available and put in "Caged nut" M8-pos. 13
2. Disassemble a plastic cover
10
3. Put distance sleeves (pos. 7) through the fabric chassis members holes
6
(do it outside the chassis)
4
4. Fix side brackets (pos. 4 and 5) through holes A with bolts
13 M10x100mm (pos. 10) and through holes B by bolts M8x35mm (pos. 9)
to the car chassis.
9
Attention! Put fish-plates (pos. 6) between brackets (pos. 4 and 5) at
points B and body of the car.
5. Slide main bar of the towbar (pos. 1) between installed brackets (pos. 4
and 5) and fix it with bolts M12x35mm (pos. 9)
9
6. Tighten all nuts and bolts according to the torque shown in the table
B
7. Reassemble the plastic cover.
8
8. Fix body of the automat (pos. 23) and the socket plate (pos. 3) using
bolts M12x25mm (pos. 8) from accessories. Place tow-ball (pos. 2)
according to supplied instruction.
9. Connect the electric wires according to the instructions of the car
10. Complete the paint cover of towbar (during the mounting paint cover
could be destroyed).
2
M6 - 11 Nm
M12 - 87 Nm
After install the towbar you should get adequate note in registration book
(at authorised service station). The car should be equipped with:
• Indicators
• Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar
must be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M8 - 25 Nm
M14 - 138 Nm
NOTE
M10 - 50 Nm
M16 - 210 Nm