AUTO-HAK G27A Instructions De Montage

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
1
C
B
6
11
4
10
9
D
This towbar is designed to assembly in following car:
RENAULT KANGOO, produced since 07.1998 till 2008, catalogue no.
G27A and is prepared to tow trailers max total weight 1350 kg and max
vertical load 75 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
11
6
C
B
5
A
8
3
7
10
From manufacturer
1. Take out the spare wheel.
2. Put the element (pos. 5) through the fabric holes.
10
3. At the bottom of car position the main bar of the towbar (pos. 1) to the
rear panel, then fit it with M10x90mm (pos. 10) through the holes (pos.
A) and nuts M10 together with the connecting pieces through the holes
(pos. B).
4. Put the sleeves (pos. 6) from the internal side to the right and left chassis
4
member.
5. Position the brackets (pos. 4) and fit it through the holes (pos. C) and the
sleeves with M10x90mm (pos. 10) from the towbar accessories.
6. Fit the brackets to the main bar through the holes (pos. D) using bolts
9
M12x35mm (pos. 9).
7. Fix body of the automat (pos. 18) and the socket plate (pos. 3) using
D
bolts M12x25mm (pos. 8) from accessories. Place tow-ball (pos. 2)
according to supplied instruction.
8. Tighten all nuts and bolts according to the torque shown in the table.
9. Connect the electric wires according to the instructions of the car.
Complete the paint cover of towbar (during the mounting paint cover
10.
could be destroyed).
2
M6 - 11 Nm
M12 - 87 Nm
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
• Indicators
• Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar
must be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M8 - 25 Nm
M14 - 138 Nm
NOTE
M10 - 50 Nm
M16 - 210 Nm