AUTO-HAK G36 Instructions De Montage

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
7
4
6
6
This towbar is designed to assembly in following cars:
RENAULT MASTER and OPEL MOVANO (both loading platform)
produced since 1998, catalogue number G36 and is prepared to tow trailers
max total weight 2300 kg and max vertical load 100 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be installing in points described by a car producer.
3
7
6
1
2
18
A
17
From manufacturer
1. Fix brackets (pos. 3 and 4) at original threaded holes in
chassis frame using bolts M12x35mm (pos. 6) and
M10x35mm (pos. 7). See drawing.
A
2. Between mounted brackets slip main bar of towbar (pos. 1)
6
and fix it by bolts M12x35mm (pos. 6) through holes A.
3. Fix tow-ball (pos. 2) and using bolts M16x50mm (pos. 5)
from accessories.
4. Fix socket plate (pos. 17) using bolt M10x30mm (pos. 18).
5. Tighten all bolts according to the torque shown in the table.
6. Connect electric wires of 7-pole socket according to the
instruction of the car. (Recommend to make at authorized
service station)
7. Complete paint layer damaged during installation.
5
M6 - 11 Nm
M12 - 87 Nm
After install the towbar you should get adequate note in registration book
(at authorised service station).The car should be equipped with:
• Indicators
• Tow mirrors
After 1000km check all bolts and nuts. The ball of towbar must be always
kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M8 - 25 Nm
M14 - 138 Nm
NOTE
M10 - 50 Nm
M16 - 210 Nm