AUTO-HAK D12 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
5
6
8
9
10
10
This towbar is designed to assembly in following cars:
MERCEDES SPRINTER
VW LT 28/46 produced since 01.1996 till 03.2006
3.05m, without footstep, built-up, catalogue no. D12 and is prepared to tow
trailers max total weight 2800 kg and max vertical mass 100 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and correct
exploitation. For this reasons we kindly ask to read carefully this instruction and
apply to hints. The towbar should be installing in points described by a car
producer.
6
5
1
3
A
11
B
4
produced since 02.1995 till 05.2006
From manufacturer
8
1. Fix main bar of the towbar (pos. 1) with side brackets (pos. 5) using
12x35mm bolts (pos. 9) from towbar accessories.
2. In this way prepared towbar put below the car and through fish-plates
(pos. 6) fix to the frame using M12x100mm bolts (pos. 8).
3. Handles (pos. 4) fix through holes (pos. A) with chassis frame and
9
next through holes (pos. B) twist to main bar of the towbar using
8
bolts M10x35mm (pos. 10) from accessories.
A
4. Fix tow-ball (pos. 2) using bolts M16x50mm (pos. 7) from towbar
accessories.
8
5. Fix the socket plate (pos. 3) using bolt M10x30mm (pos. 11) as shown
B
on the drawing.
6. Tighten all bolts according to the torque shown in the table.
7. Connect electric wires of 7-pole socket according to the instruction of
21
the car. (Recommend to make at authorized service station)
2
8. Complete paint layer damaged during installation.
7
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
Check all bolts and nuts after 1000km of exploitation. The ball of towbar must be
always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M6 - 11 Nm M8 - 25 Nm
M12 - 87 Nm M14 - 138 Nm
NOTE
M10 - 50 Nm
M16 - 210 Nm