AUTO-HAK O05 Instructions De Montage

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
Fig. 1
This towbar is designed to assembly in following car:
TOYOTA AVENSIS 4-5 doors, produced since 1997 till 12.2002,
catalogue no. O05, and is prepared to tow trailers max total weight 1400 kg
and max vertical load 75 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
1
3
From manufacturer
1. Disassmble the bumper.
2. Unscrew original tow handles (not used any more).
3. Put main bar of the towbar (pos. 1) to the car and in places original tow
hadles fix it using original bolts.
4. Cut out fragments of the bumper (see fig. 2). Fragment 50x70mm - in
lower part in axis of the bumper.
5. Fix tow-ball (pos. 2) and socket plate (pos. 3) using bolts M12x75mm
(pos. 4) from accessories.
6. Fix tight all bolts according to the torque shown in the table.
7. Connect electric wires according to the instruction of the car.
(Recommend to make at authorized service station).
8. Supplement the paint coating damaged during assembly.
4
2
Fig. 2
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
•
Indicators
•
Tow mirrors
After 1000km check all bolts and nuts. The ball of towbar must be always kept
clear and conserve with a grease.
The instruction of the assembly
50
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE
Cut out