Luda Flexi Pack Mode D'emploi page 5

Installation
1. Cut the camera cable according to picture using a cable cutter or similar tool.
2. Place the large 10 cm shrink tube (E) over the camera cable.
3. A. Strip the outer black rubber jacket 4 cm without damaging the inner cables.
B. Strip the inner cables 1 cm without damaging the metal wires.
4. Put the RED camera inner cable and the
red striped shrink tube (D) with the metal overlapping. Repeat step 3-4 with the BLACK cables.
5. A. Clasp with a plier the center metal part tight over the inserted cables.
B. Heat the red striped shrink tubes carefully until fitting snugly.
C. Pull the 10 cm shrink tube over the gap and heat carefully until fitting snugly.
6. Attach the magnet to the camera mounting foot using the supplied nuts and bolts.
Optional – Do you need to go back to fixed power source?
Disconnect the camera from the battery at the power plug and connect the loose cable (C) to the
camera power contact.
Important! Keep silicone caps on when the connector is not in use.
Operation
Connect the camera and Flexi Pack (A) and tighten the connector
Power ON: hold the button on the Flexi Pack for more than 3 seconds until you see one/two/three
red flashes
Power OFF: hold the button on the Flexi Pack for more than 3 seconds until you see four red
flashes
Battery check: press the button on the Flexi Pack one time for less than 3 seconds
4 RED flashes: Full power
3 RED flashes: Medium power
2 RED flashes: Low power
1 RED flash: Recharge
Recharge by connecting charger (F) to the Flexi Pack (A)
GREEN light ON: Battery charging
GREEN light OFF: Fully charged
Approximate charging time of empty battery, up to 14 hours to fully charged battery.
info@ludaelektronik.se | Tel. +46 31 31 30 290 | www.ludaelektronik.com
English – Flexi Pack
RED cable from the male connector (B) inside of the
LUDA Flexi Pack – User Guide – 2012
- 5 -