Manitowoc iAuCS Manuel D'installation, D'utilisation Et D'entretien page 10

Installation
CpIIunicaripn Wire and Vinyl Tubing
The communication wire and vinyl tubing must be installed
in conduit to protect them from damage.
1. Remove the 7/8" knockout hole plug located on the
back of the ice machine.
2. Install conduit from the AuCS® unit to the ice machine.
A pulling elbow is recommended for easier routing of
the vinyl tubing and modular wire.
3. Route low voltage communication wire and vinyl
tubing together through the conduit.
4. Route modular wire through control box low voltage
Heyco fitting. Do not route with line voltage wiring, as
erratic operation could result. Connect modular wire to
control board.
5. Connect the communication wire to the AuCS control
board.
iAuCS
CpIIunicaripn
Plug Cpnnecripn
Cpnrrpl Bpard
10
Vinyl Tubing Cpnnecripn
1. Remove the water trough.
A. Depress tabs on right and left side of the water
trough.
B. Allow front of water trough to drop as you pull
forward to disengage the rear pins.
2. Locate the water inlet tube on the right hand side (see
below) of the ice machine base.
• After serial number 1101246915 - Use a screwdriver
to remove membrane.
• Before serial number 1101246915 - Press up on the
plug until it is out.
Lpcaripn
Press um pn
bprrpI pf mlug
rp mpm pur
Warer
nler
Plug
Tubing
Afrer Serial NuIber
1101246915 use
screwdriver rp
reIpve IeIbrane
Part Number 000009036 8/13
Section 2