AUTO-HAK T43 Instructions De Montage page 4

FITTING INSTRUCTION
11
C
B
7
A
3
2
This towbar is designed to assembly in following cars:
KIA CARENS I II,
(FC, FJ) VAN,
catalogue no. T43 and is prepared to tow trailers max total weight 1250 kg
and max vertical load 75 kg.
Thank you for buying our product. Their reliability has been
confirmed in many tests. Reliability of towbar depends also on correct
assembly and right exploit. For this reasons we kindly ask to read carefully
this instruction and apply to hints.
The towbar should be install in points described by a car producer.
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
8
2 + Rear fog lights
3 31 Ground
6 4 R Right directional lights
5 58R Right side parking lights
D
6 54 Stoplights
7 58L Left side parking lights
11
1
B
7
4
A
14
12
produced since 01.2000 till 08.2006,
From manufacturer
1. Lower the exhaust then remove the rear lights.
2. Remove the floor cover of the luggage trunk then loose the side plastic
covers and fold them to the center of the trunk.
3. Remove the bumper and its inset then remove the bumper brackets (these
will not be reinstalled later).
4. Enlarge the „C" factory holes on the floor plate of the trunk with a ø18mm
drill.
5. Put the accessories pos. 5 and 6 into the chassis extension then according
to the drawing loosely fix them at positions „B", „C" and „D" with the
attached bonding units (The accessory plates pos. 7 will be placed into the
trunk, remember about distance sleeves pos. 8!).
6. According to the drawing loosely fix the drag hook body (1) to the
accessories 5 and 6 at positions „A" with bolts M12x85mm pos. 12.
7. Using bolts M8x30 pos. 14 fix inset of the bumper.
C
8. Fix tow-ball (pos. 2) and socket plate (pos. 3) using bolts M12x75mm
5
(pos. 4) from accessories.
9. Tighten all bolts according to the torque shown in the table.
10. Reassemble bumper after cut out his fragment (80x35mm) in his bottom,
D
central part. Next reassemble the rear lights.
11. Connect electric wires of 7-poles socket according to the instruction of the
car. (Recommend to make at authorized service station)
12. Complete paint layer damaged during installation.
Torque settings for nuts and bolts (8,8):
M 8
M 12 85 Nm
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km check all bolts and nuts. The ball of towbar must be always kept
clear and conserve with a grease.
Fitting instructions
25 Nm M 10 55 Nm
M 14 135Nm
NOTE