AUTO-HAK T47 Instructions De Montage

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
6
10
7
5
5
7
11
This towbar is designed to assembly in following car:
KIA CERATO, catalogue no. T47, produced since 2004 till 2008 and is prepared
to tow trailers max total weight 1450 kg and max vertical load 56 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and correct
exploitation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
5
10
7
1
5
4
19
18
2
3
From manufacturer
1. Disassemble the rear bumper.
2. Detach reinforcement of the bumper. From reinforcement detach fasteners
(not used any more) and detach small fasteners on the left side – see figure 2.
Fig. 2
7
11
3. In the lower part of the bumper cut out fragment according to figure 3.
4. Put main bar of the towbar (pos. 1) into chassis members this way, so holes in
main bar agree with holes in chassis members and fix it by bolts M10x40mm
(pos. 5).
5. Reinforcement of the bumper fix to the towbar using bolts M8x25mm (pos. 7).
6. Fix the bumper together with polystyrene of the fulfillment.
Fig. 3
Fig. 1
7. Screw tow-ball (pos. 2) and socket plate (pos. 3) using bolts M12x75mm (pos.
4) from accessories.
8. Tighten all bolts according to the torque shown in the table.
9. Connect electric wires of 7-poles socket according to the instruction of the car.
(Recommend to make at authorized service station)
10. Complete paint layer damaged during installation.
The instruction of the assembly
detach
detach
Torque settings for nuts and bolts (8,8):
M 8 25 Nm M 10 55 Nm
M 12 85 Nm M 14 135 Nm
cut out