Bond BLOOMINGTON Y95893 Guide D'utilisation page 7

ASSEMBLY INSTRUCTIONS
4. Insert and pull out the power cord plug of the
pump through the hole on the side wall of the
fountain base (B).
5. Place the pump (E) into the fountain base (B)
and attach the top fountain (A) to the fountain
base using 4 M8xL30 screws (BB) and 4 washers
(CC), tighten with allen wrench (EE). Then attach
the 4 plastic caps (DD).
NOTE : Make sure the operation hole on the top
fountain base aligns with the drain hole at the
bottom of the fountain base.
6. Pour clean water into fountain base through
the operation hole on the bottom plate of top
fountain (A), make sure the water pump is fully
submerged to prevent pump damage. View the
water level through the operation hole, make
sure the the water level is between the Max fill
line and Min fill line on the wall inside the fountain
base (B).
A
7
B
DD
BB
CC
B