EarthWise SN70016 Manuel Du Propriétaire page 8

Wheel bracket (Fig. 1E)
Align the holes on the wheel bracket with the holes on
the upper cover. Secure into place with ST3.9x55 Philips
head self tapping screws in the two (2) top holes and the
ST3.9x55 Philips head self tapping screws in the two (2)
bottom holes.
Auxiliary handle (Fig. 2)
Position the auxiliary handle so that the holes are in
alignment with the holes in the handle support bracket.
Insert the M6X50 hex head bolt into the hex shaped bolt
hole of the bracket. Secure by tightening the wing nut
onto the bolt.
Loosen the wing nut and adjust the angle and height of
the handle to a safe and comfortable position. Secure
into place by tightening the wing nut onto the bolt.
2
2x ST3.9X55
M6x50 Hex
Head Bolt
ASSEMBLY
Connecting the electrical cord (Fig. 3)
Loop the extension cord and feed it through the rear
handle. Rest the cord around the cord hook. This will
help prevent you from disconnecting the extension cord
from the product during operation.
WARNING: Do not handle the plug or the snow
thrower with wet hands or while standing in water.
DANGER: Electric shock can cause serious
injury or death.
3
8
Model SN70016