Instructions For A Correct Installation - Modine IDE Serie Manuel Technique

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Important

1 . Keep this manual for the lifespan of model .

2 . Read technical manual carefully before installation and prior to

any intervention on model .

3 . Use model exclusively for the purpose for which it has been

designed; misuse exempts manufacturer from any responsibility .

Inspection - Transport

1 . Upon delivery immediately examine condition of model; should

damages be detected promptly notify forwarder .

2 . During transport of model it is necessary to avoid pressure on

packaging and it must be kept in upright position as indicated

on package .

3 . Unpack model as close as possible to installation site . When

packaging is removed from model, care must be exercised in

order to avoid damage to parts .

4 . In order to avoid injury from the model's sharp edges (e .g .

fins) during installation and positioning of model use of special

protective gloves is recommended .

For a proper installation

1 . Verify structural bearing of ceiling in relation to the weight of

the unit .

2 . Verify that the unit is installed horizontally .

3 . Ensure an adequate free space (approx . 30% of the inner

room volume) to allow a proper intake and exhaust air circula-

tion .

Particular conditions of installation or operation such as

low or beamed rooms, overstorage, obstructed intake and

exhaust air circulation and improper ice build-up due to

excessive entry of humidity in room may negatively affect

the stated performance and may cause defects.

Standard models may not be suitable for blast freezer and

chill room application.

4 . The models are equipped with axial fan motors, therefore not

suitable for duct ventilation systems and cannot sustain extra

static air pressure drops .

5 . Verify that the operating conditions (temperatures and pres-

sures) are in accordance to those of project .

6 . Care must be exercised during the connecting phase in order

to avoid possible distortion of the capillary tubes and shifting

of the distributor .

7 . In the case of more than one model installed at close range it

is advisable to avoid alternate defrostings .

8 . Fit the appropriate siphons on the condensate drain con-

nections and assess their efficiency in all working tempera-

tures .

9 . Avoid installation of the units next to the cold-room doors .

10 . Place the end of defrost temperature feeler in the coldest

areas of the coil, i .e . the areas that tend to freeze more (at

the end of the cycle the unit should be completely ice-free) .

The position of this device cannot be defined in advance,

because it varies in accordance to the type cold room and

type of installation .

11. Verify that the electrical feed network is in accordance to the

electrical features of model .

12. Ensure that all the electric wiring is in compliance with the

standards in force .

13. The protective film is to be removed from model upon comple-

tion of installation .

14. Access to model, for any type of intervention, is reserved to

qualified personnel as per regulations in force .

General Maintenance

1 . Periodically inspect fastenings, electrical connections and

connections to cooling installation .

2 . It is necessary to arrange periodical cleaning of unit in order

to avoid deposits of toxic substances . Use of mild detergent is

recommended; avoid use of solvents, aggressive, abrasive or

ammonia-based agents .

3 . When replacing electric heaters take particular care during

installation in order to avoid damage to the vulcanization;

correctly reset wiring and existing fastening systems to avoid

possible movement during operation .

The above-mentioned operations are to be carried out by

qualified personnel only.

Caution

before carrying out maintenance on unit, make sure that the

electric feed is disconnected from main power source: the

electric parts may be connected to an automatic control sys-

tem .