Recommendations For A Proper Access To The Model - Modine AP Serie Manuel Technique

8. Recommendations for a proper access to the model

Preliminary assembly
8.1 EP - EP-ED series: connect the heater R0 and motors through entry knockout L4; to avoid possible damage to wires use
the rubber fairlead supplied separately with unit.
8.2 EP/B - EP/B-ED series: the heater R0 and the motors are prewired in junction box SD; use entry knockout L4 and rubber
fairlead supplied with unit for all electric connections.
Access/Repositioning
8.3 Use screws A to remove or reposition fan shroud L2 and drain pan L1.
8.4 To remove the heater R0, remove the heater clips MF and pull the heater out from below.
L1 = Drain pan
L2 = Fan shroud
L3 = Casing
L4 = Entry knockout
MF = Heater clip
R0 = Heater
SD = Junction box (fans and heaters) standard on B models
26
www.modine.com
Figure 3