AUTO-HAK D11 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
A
6
5
4
8 9
This towbar is designed to assembly in following car:
MERCEDES VITO (Class V), produced since 1996 till 06.2003,
catalogue no. D11 and is prepared to tow trailers max total weight 2000 kg
and max vertical load 100 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
6
A
5
1
B
3
From manufacturer
8
1. Disassemble the rear bumper.
2. Position three distance sleeves pos. 6 (L=62) per each side to
holes on the left and right side of chassis members.
3. Put main bar of the towbar (pos. 1) to chassis members as
shown in the drawing no. 1 and screw using bolts
M12x100mm (pos. 8) through holes (pos. A), distance sleeves
(pos. 6) and with rectangular plates (pos. 4) from accessories.
4
B
4. To existing holes in rear side of car slip nuts M10 on the jib
(pos. 5) and screw through holes (pos. B) using bolts
9
M10x30mm (pos. 9).
5. Install the bumper after cut out the fragment in its axis (width
50mm, depth 30mm).
7
6. Fix tow-ball (pos. 2) and socket plate (pos. 3) using bolts
15
M12x75mm (pos.7) from accessories.
7. Tighten all bolts according to the torque shown in the table.
8. Connect electric wires of 7-poles socket according to the
instruction of the car. (Recommend to make at authorized
service station)
2
9. Complete the paint coating damaged during installation.
Fig.1
After install the towbar you should get adequate note in registration book
(at authorised service station).The car should be equipped with:
• Indicators
• Tow mirrors
After 1000km check all bolts and nuts. The ball of towbar must be always
kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M 8 25 Nm M 10 55 Nm
M 12 85 Nm M 14 135 Nm
NOTE