Festo DAPZ−SB−M−250AC−DR−AR Notice D'utilisation page 35

DAPZ−...−AR
Fitting the visual display
Please note
The following conditions must be fulfilled when the visual display is fitted:
the 2/2−way valve must be closed
the 3/2−way valve can be in any switching position.
Fitting the red/green rings
Check the relative position of the red ring 1 and the green ring 2 to each
S
other.
If necesary, turn the red ring in the guide of the green ring until the lower
S
edges of the red ring and the green ring are flush with each other.
Fig. 23
Align the internal double surface of
S
the red ring with the double surface of
the cam shaft.
Push the four steps of the green ring
S
into the guides on the housing of the
DAPZ−...−AR.
Carefully turn the red ring backwards
S
and forwards until it can be pushed
onto the cam shaft.
Make sure that the steps of the green
ring remain in the guides.
Festo DAPZ−...−AR 0711b English
Fig. 24
Fig. 25
1
2
35