Vent Sensor (Dv50F9A8E(G)*) - Samsung DV50F9A6E Serie Manuel De L'utilisateur

operating instructions, tips

VEnT SEnSoR (DV50F9A8E(G)*)

Your Samsung dryer is equipped with a Vent Sensor, which detects and notifies you when it is time to clean
the ductwork. Keep your dryer safe and efficient by cleaning the ducts when prompted.
The Vent Sensor detects any duct blockages
You can fi gure out whether there is a duct blockage from the "Vent Sensor " lamp of the
digital display.
Level
0
1
2
In the LEVEL 2 state, this lamp blinks for 3 hours after the completion of the cycle. (If the wrinkle
prevention function is activated, this message is displayed for up to 3 hours.)
If the power button is pressed or the door is opened, the power is immediately turned off.
For more information about the duct installation, please refer to the "Ducting requirements"
section on page 10.
• Although the dryer is available even if the blockage message is displayed, the drying time
may be extended.
• If the LEVEL 1 message is displayed the fi rst time the dryer is run after the installation,
check the connection and clean the duct. If the LEVEL 1 message appears even
after you have checked and cleaned the ducts, this may indicate that there are some
restrictions of the duct due to the length, condition, etc.
If this occurs, you can use the dryer normally and no countermeasures need to be taken.
However, the drying time may be extended or the drying performance may be degraded.
30_ operating instructions, tips
F900A DRY_DV50F_USER MANUAL_DC68-03170D-05_EN.indd 30
Message
The "Vent Sensor "
lamp is turned off .
The "Vent Sensor "
lamp illuminates.
The "Vent Sensor "
lamp blinks.
Status
The ductwork is free from
blockages.
When a part of the duct
or the lint fi lter is blocked
by lint or a foreign object.
When the resistance is
high because the duct is
too long or bent.
When the duct is blocked
by lint or a foreign object.
When the resistance is
very high because the
duct is too long or bent
excessively.
Solution
-
Check the duct
connection and shorten
the duct and straighten it
if necessary.
Check the lint fi lter or
the duct and clean it if
necessary.
Check the duct
connection and shorten
the duct and straighten it
if necessary.
Check the lint fi lter or the
duct and clean it as soon
as possible.
2014/3/18 15:00:06