Samsung DV50F9A6E Serie Manuel De L'utilisateur page 25

digital Graphic
2
display
dry level
3
selection button
Temp selection
4
button
F900A DRY_DV50F_USER MANUAL_DC68-03170D-05_EN.indd 25
Towels – To dry bath towels and similar items.
Wool (DV50F9A7E(G)*) – For machine washable and tumble dryable wool
only.
Sanitize – Sanitizes garments by infusing high temperature heat deep into
the fabric during the drying cycle. Use this course to keep your bedding and
curtains clean through sanitization.
Time Dry – Time Dry allows you to select the desired cycle time in minutes.
Turn the Cycle Selector dial to Time Dry, and then press the Adjust Time up
arrow to set the drying time. Press the arrow repeatedly to scroll through the
time settings.
quick Dry - Provides a 30 minute drying cycle.
Air Fluff – The Air Fluff cycle tumbles the load at room temperature air.
Rack Dry (DV50F9A8E(G)*) – Dry special items as using to drying rack. (refer
to items of page 28 for detail).
Steam Sanitize (DV50F9A7E(G)*/(DV50F9A8E(G)*) – Sanitize garments by
infusing high temperature heat deep into the fabric and injecting steam
during the drying cycle. This course can make clothes soft and remove bad
odors after drying.
Refresh – Use to smooth out wrinkles and reduce odors in loads of one to
four items. In this cycle a small amount of water is sprayed into the dryer
drum after several minutes of tumbling with heat.
Wrinkle Away – Reduce wrinkles in dry clothes that have been left in a
closet for a while by providing advanced wrinkle release performance through
optimized steam care. Reduced wrinkles in up to 3 items at a time.
You can change the drying time using the Adjust Time button.
- You can increase or decrease the cycle time, but you cannot select a time
lower than the lowest pre-set automatic drying time (20 minutes).
The display window shows the estimated time remaining in the cycle after
you have pressed the Start/Pause button. The estimated time remaining may
fluctuates as the cycle progresses.
The Drying light will illuminate and remain lit until the cycle is complete.
When your dryer is in the cool-down phase, the Cooling light will illuminate. When
your dryer is in the wrinkle prevent phase, the Wrinkle Prevent light will illuminate.
When the cycle is complete, "End" will appear in the display panel until you push
the Start/Pause button or the power button. If your dryer is paused during a
cycle, the indicator lights will blink until you press the Start/Pause button.
To select the dry level in the Normal, Heavy Duty, or other Sensor Dry cycles,
press the Dry Level button. An indicator light will illuminate next to the dryness
level you selected.
Press the button repeatedly to scroll through the settings. Larger or bulkier
loads may require the Very Dry or More Dry setting for complete dryness.
Damp Dry is designed to partially dry items. Use for items that lay flat or hang
to dry.
To select the temperature for the load, press the Temp button. An indicator
light will illuminate next to the temperature you selected. Press the button
repeatedly to scroll through the settings.
high – For sturdy cottons or those labeled Tumble Dry.
medium – For permanent press, synthetics, lightweight cottons, or items
labeled Tumble Dry Medium.
med Low – For heat lower than Medium. Use to dry synthetic or
washable knit fabrics.
Low – For heat sensitive items labeled Tumble Dry Low or Tumble Dry Warm.
Extra Low – Provides the lowest heated drying temperature possible.
operating instructions, tips _25
2014/3/18 15:00:05