Assembly; Operation; Cleaning And Maintenance - Lux Tools A-GS-20/20 Notice Originale

GB
Scope of delivery
• Operating manual
• Cutting equipment for hedge trimmer
• Cutting equipment border cutter
• Blade guard for hedge trimmer
• Blade guard for border cutter

Assembly

Replacing the cutting mechanism
WARNING! Risk of injury! Before chang-
ing the cutting mechanism, always fit the
blade guard.
► P. 3, item 3
– Keep the unlock button (5) pressed.
– Remove the cutting unit as shown.
► P. 4, item 4
– Ensure that the bore pins (15) grip into the driving
holes (14).
► P. 4, item 5
– Fit the cutting mechanism (7) as shown.
– Allow the cutting unit to engage audibly.

Operation

Charging the battery pack
Note: Rechargeable battery and charger
are not part of the scope of delivery and are
available optionally from your dealer
(► Accessories – p. 23).
WARNING! Risk of injury! Comply with all
safety instructions when handling recharge-
able devices.
NOTICE! Risk of damage to the unit! Do
not allow the battery pack to deep discharge.
Note: If the battery is fully loaded, the
charger automatically switches over to the
maintenance charge function. The battery
can thus remain in the charger permanently.
The battery pack must be charged prior to the first
start-up (charging time: ► Technical data – p. 23).
► P. 4, item 6
– Press in the locking button (11) and remove the
battery from the device.
► P. 4, item 7
– Insert the battery pack into the charger.
– Plug the charger into the power supply.
The charging status is displayed by the control
lights (12).
– Slot the battery pack into the device and make
sure it clicks into place correctly.
Checking the remaining capacity of the battery
– Press the button (10).
The remaining capacity of the battery is displayed by
the control lights (9).
22
Switching on and off
– Remove blade guard.
► P. 3, item 1
– Switching on: Push the switch lock (2) forward
and simultaneously press the On/Off switch (3).
– Switching off: Release the On/Off switch (3).
– After switching off wait until the blade is stationary.
– Mount blade guard.
Cutting edges
NOTICE! Risk of damage to the unit!
Ensure that the cutting mechanism does not
come into contract with paved floors, stones
or garden walls.
If foreign objects should get caught up in the
cutting unit then switch off the device imme-
diately.
– Guide the device along the edge of the lawn.
Cutting hedges
NOTICE! Risk of damage to the unit! Be
especially careful when working near
fences!
If cut material such as fence wire or similar
material should get caught up in the cutting
unit then switch off the device immediately.
NOTICE! Risk of environmental damage!
Work with the hedge trimmer is not allowed
during customary rest periods.
Before cutting a hedge, check that there are
no birds nesting.
– Trim smoothly with the broad side of the cutting
equipment. Do not push the point into the hedge.
Tips on hedge trimming
1
2
1. Trim the hedge to the desired height.
2. Rejuvenate the hedge by trimming it from the bot-
tom up in trapezoidal form.
3. Round off the upper edges of the hedge.
4. Slightly trim the bottom of the hedge.

Cleaning and maintenance

Cleaning
NOTICE! Risk of damage to the device!
Do not submerge the device in water when
cleaning it since this would damage the elec-
trics.
NOTICE! Risk of damage to the device!
Do not use any sharp or abrasive objects, or
aggressive cleaning agents.
Do not use cleaning solutions.
3
4