digirails DIGISERVO DR4024 Manuel page 17

DR4024 DIGISERVO (v1.31)
CV CV Definition
118 Switching output 2 (OUT 6)
For settings see CV117
119 Switching output 3 (OUT 7)
For settings see CV 117
120 Switching output 4 (OUT 8)
For settings see CV 117
121 Position A for servo 1
CVs 121-136 contain the various end positions of the servos. Each servo has 4 final po-
sitions: A, B, C, D. These end positions can be selected using function mapping
(see page 18)
122 Position C for servo 1
123 Position B for servo 1
124 Position D for servo 1
125 Position A for servo 2
126 Position C for servo 2
127 Position B for servo 2
128 Position D for servo 2
129 Position A for servo 3
130 Position C for servo 3
131 Position B for servo 3
132 Position D for servo 3
133 Position A for servo 4
134 Position C for servo 4
135 Position B for servo 4
136 Position D for servo 4
137 CVs 137-140 contain the mass simulation values.
If the value is not equal to 0, the servo will alternately add and subtract this value at
the end position, whereby the value is also decreased by 1 each time, until the value
reaches 0.
This causes the servo to oscillate back and forth less and less around its end position. A
precondition for this working is that the end position + the bounce value is less than
255 and that the end position - the bounce value is greater than 0.
138 Mass simulation value for servo 2 (see CV137)
139 Mass simulation value for servo 3 (see CV137)
140 Mass simulation value for servo 4 (see CV137)
Pagina / page / Seite / page 17
Range Value
0-255 1
0-255 1
0-255 1
0-255 224
0-255 176
0-255 32
0-255 80
0-255 224
0-255 176
0-255 32
0-255 80
0-255 224
0-255 176
0-255 32
0-255 80
0-255 224
0-255 176
0-255 32
0-255 80
0-63 0
0-63 0
0-63 0
0-63 0