Publicité
Les langues disponibles
Les langues disponibles
DR4024 DIGISERVO (v1.31)
Setting up the servo positions
Follow this procedure to set up the servos:
1.
Connect the decoder to the power and the control unit.
2.
Set your control unit to
3.
Turn off F1, F2, F3 and F4 on your control unit
4.
Set the speed to 0
5.
Operate the servo you want to program
6.
Press the switch on the module. The LED will turn on.
The selected servo moves to the centre position.
7.
Turn the dial (7) clockwise to set the servo to the desired position A.
8.
Switch F1 on and then off to save position A in the module.
9.
Switch the travel direction on the control unit by pressing dial (7) in once.
10.
Turn the dial (7) clockwise to set the servo to the desired position B.
11.
Switch F2 on and then off to save position B in the module.
12.
Switch the travel direction on the control unit by pressing dial (7) in once.
13.
Turn the dial (7) clockwise to set the servo to the desired position C.
14.
Switch F3 on and then off to save position C in the module.
15.
Switch the travel direction on the control unit by pressing dial (7) in once.
16.
Turn the dial (7) clockwise to set the servo to the desired position D.
17.
Switch F4 on and then off to save position D in the module.
Important: when the decoder saves a position, the LED will turn off briefly to show the position has been
stored.
18.
Press the button on the module to exit the programming mode.
19.
Repeat the above steps for each servo output.
TIP: You automatically select the next servo with F0 / turning the light on and off again.
4
3
7
loc address
9999 (128 steps DCC)
2
Pagina / page / Seite / page 14
5
A
B
C
D
Publicité
