Publicité
Les langues disponibles
Les langues disponibles
How to Use:
CLEANING YOUR HARD FLOORS
*Not for Use on Hard Wood Floors
IMPORTANT CLEANING TIP:
before deep cleaning. Always test in inconspicuous area with small amount of cleaner before using.
Prepare Machine
1
Raise the Main Handle
Make sure Handle of the
Pro Deep Cleaner is in the
upright position (as seen to
the right) until handle locks
securely.
2
Check the
Power Button
Make sure that the
Power Button is in
the "off" position.
3
Add Cleaning
Solution
Add Rug Doctor Pro
Hard Floor Cleaning
Solution and warm
water to the Clean
Water Tank as per
the cleaning solution
instructions.
Assemble the Wand
1
Connect and Assemble the Wand
Align components and connect 2 bars
together to make one Wand.
6
Clean area with a dry vacuum or microfiber mop thoroughly
Fill Line
2
Connect the Hard Surface Tool
Align components and attach the
Hard Surface Cleaning Tool head to
the lower end of the Wand.
M O T O R I Z E D H A R D F L O O R C L E A N I N G T O O L
*
Connect the Hoses
1
Open the
Vacuum Hose Port
Pull the black rubber
flap upward to open
the Vacuum Hose Port.
2
Connect the
Vacuum Hose
Insert the Vacuum
Hose Cuff into the
Vacuum Hose Port
(marked "A").
3
Connect the
Solution Hose
Insert the Solution
Hose into the
Solution Hose Port
(marked "B").
3
Connect the Wand to the
Handle/Hose
Align components and attach the
Wand to the open end of the
Handle/Hose.
|
U s e r M a n u a l
Publicité
