Inficon D-TEK CO2 Mode D'emploi page 8

Replacing the Battery
1. Ensure D-TEK CO
2. With one hand, firmly press the square release buttons on either side of the
rubberized grip.
3. With the release buttons pressed, remove the battery door by pulling out from
the bottom of the instrument.
NOTE: Wiggling the battery door may help.
4. Carefully unplug the electrical connector by pulling straight out.
5. Slide the battery out and discard appropriately, in accordance with local
regulations.
6. Slide a new battery in where the old battery was removed.
7. Carefully connect the electrical connector.
8. Squeeze the battery door tabs and replace the battery door.
NOTE: Ensure the battery wires are clear of the battery door.
9. Connect D-TEK CO
10 to 12 hours to ensure a full charge.
NOTE: If the power indicator, HI, and LO indicators alternate flashing while the
wall charger is connected, the battery may be unplugged or the connector
is backwards. This could also indicate a faulty battery.
is OFF and not connected to any power source.
2
to a car or wall charger and allow the battery to charge for
2
8