THOMSON HTS4500W Mode D'emploi page 17

USE
Turn on/Turn off
• Turn the POWER switch at the rear side of the subwoofer to the position ON/OFF.
• Turn the POWER switch at the rear side of the two wireless speakers to ON/OFF.
• Volume level appears on the LCD screen.
Source input selection
• Press INPUT to choose among sources 6ch - AU - OP - CO1 - CO2.
• 6ch: input 5.1.
• AU: analogue input.
• OPT: optical input.
• CO1: coaxial input 1.
• CO2: coaxial input 2.
6ch(5.1CH)
AU
Audiomode
• Press MODE to switch to modes 2.1 ort 5.1 virtual.
Volume setting
Every time the device is started, volume is automatically set at 30. Max. value is 63.
• Press VOL+/VOL- on the subwoofer or the remote control to increase/decrease the
sound volume.
Sound setting (Speakers)
These keys adjust the volume settings of the different parts of the Home Theater. These
settings can only be adjusted from the remote control.
• Press FRONT +/- to adjust the front speakers volume.
• Press CEN +/- to adjust the center speakers volume.
• Press SURR +/- to adjust the rear speakers volume.
• Press SW +/- to adjust the subwoofer volume.
Note: The subwoofer is connected to the rear speakers via a wireless system.
Reset sound settings
• Press RESET on the remote control to reset all independent sound settings.
Sound off mode
• Press MUTE on the subwoofer or the remote control to turn the sound on or off.
OP CO1 CO2
HOME CINEMA 5.1
HTS4500W
TECHNICAL SPECIFICATIONS
• Power supply = AC 230V/50Hz
• Total power consumption = 100W
• Input sensitivity (subwoofer) = 100mV ± 20mV
• Input sensitivity (satellite speakers) = 750mV ± 50mV
• Speaker impedance (subwoofer) = 8 Ohm
• Speaker impedance (for each satellite) = 8 Ohm
• S / N (A) Weight = 75dB
• Subwoofer output power : = 35W
• Front speaker output power = 13Wx2
• Center speaker output power = 13W
• Rear speaker output power = 13Wx2
• THD (1 kHz, 1 W) = 0.5%
• Frequency response = 20 Hz ~ 20 kHz ± 5dB
• L / R separation (1 kHz) = 30dB
• L / R stereo balance = ±2 dB
• Total output power = 450W
15 EN