THOMSON HT121SB Mode D'emploi page 15

Carefully read the instructions of this manual, respecting recommendations for use and safety. Keep this document and
tell potential users about it.
of any professional use, any misuse or any use not complying with the operating instructions.
This symbol, representing a lightning bolt inside
an equilateral triangle, is intended to alert the
user to the presence of uninsulated, dangerous
voltage in the product's enclosure that is high
enough to present a risk of electrical shock.
This symbol, representing an exclamation mark
inside an equilateral triangle, is intended to
alert the user to the presence of operating and
maintenance instructions in the documentation
accompanying the product.
This appliance complies with the standards in
force for this type of product.
This appliance bears the WEEE mark (Waste of
Electric and Electronic Equipment) signifying
that, at the end of its life cycle, it should not
be disposed of with household waste, but at a
recycling centre.
The recycling of waste contributes to the
conservation of our environment.
Disposing of batteries at the end of their life
In order to respect the environment, do not
throw used batteries out with household waste.
Dispose of them at your nearest recycling centre
or at a used battery collection point.
ATTENTION: This symbol
indicates that this appliance is a
Class 1 Laser product.
CLASS 1 LASER PRODUCT
look at the laser beam.
inside the compartment.
Manufactured under license to
and the double-D symbol
are trademarks of Dolby
Laboratories.
HOME THEATER
HT121SB
SAFETY REGULATIONS
WARNING CONCERNING USE AND INSTALLATION
etc.) on the appliance.
heating equipment or any heat source, or in a location
The appliance is designed for use in moderate climates.
ash tray, etc.) close to the appliance.
stable.
designed to work solely in a horizontal position.
ventilation to avoid internal overheating. Avoid
restricted spaces such as bookcases, cabinets, etc.
a carpet or blanket, that might block the ventilation
openings.
the appliance unsupervised.
appliance.
transient phenomena, the product may not operate
properly and will need to be reset by the user.
with powerful magnets, such as microwave ovens or
powerful loudspeakers.
this could damage it and affect the disk. Remove the
disk before you move the appliance.
to a hot location, condensation may form on the
lens located inside the disk compartment. Leave the
appliance for at least 30 minutes before switching it on.
it must remain readily operable. For the appliance to
be completely disconnected from the electrical power
supply, the mains plug of the apparatus must be
unplugged completely from the wall socket. The mains
plug should not be obstructed or should be readily
accessible during use.
13 EN