Door And Filter; Opening The Door; Filter; Filter Care Indicator - Candy Grand O Comfort GCC 781NBT Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Opening the Door

WARNING! When the tumble dryer is in
use the drum and door may be VERY HOT.
Never stop a tumble dryer before the end of the
drying cycle unless all items are quickly
removed and spread out so that the heat is
dissipated.

Filter

IMPORTANT: To maintain the efficiency of the
dryer check that the fluff filter is clean before
each drying cycle.
1 . P u l l t h e f i l t e r
upwards.
2. Open filter as shown.
3.Gently remove lint
using a soft brush or
your fingertips.
4 . S n a p t h e f i l t e r
together and push
back into place.

Filter Care Indicator

Lights when the
filter needs cleaning.
If the laundry is not
drying check that the
filter is not clogged.
DO NOT USE WATER TO CLEAN THE FILTER.
EN
10
Pull on handle to open
the door.
To restart the dryer,
close the door and
press .

DOOR and FILTER

The water removed from the laundry during
the drying cycle is collected in a container
inside the door of the dryer. When the
container is full the
panel will light, and the container MUST be
emptied. However, we recommend that the
container is emptied after each drying cycle.
NOTE: Very little water will collect during the
first few cycles of a new machine as an internal
reservoir is filled first.

To Remove the Container

1.
Gently pull out the
t r a y
u n t i l
i t
completely removed.
Support the tray with
both hands. When it is
full the water container
will weigh about 4kg.
2 . Ti l t t h e w a t e r
container to empty the
water out through the
rear hole.
When emptyslide the
water container back
into position.
PUSH FIRMLY INTO
PLACE.
3. Press
to restart
the cycle.
NOTE: If you have the
option of drainage near
the dryer it is possible
to use the discharge kit
to provide a permanent
drain for the water
collected by the dryer.
This will remove the
need to empty the
water tray. All the
i n f o r m a t i o n
f o r
assembly of the kit is
contained in the kit
envelope.
indicator on the control
i s

Publicité

Table des Matières
loading

Table des Matières