Installation; Installation Conditions - Polytropic Advance S Manuel D'instructions

Installation

Installation conditions

Installation location
The pool heat pump must be installed outdoors with a distance greater than 3 m
from the Pool according to laws in force (NF C 15 100).
Install the pool heat pump on a flat, horizontal, and stable surface. (Concrete base
would be ideal).
Maintain at least 1 m (40 ") of space on the rear (evaporator air inlet) and 3m (120 ") on
the outlet side of the fan on a completely free space.
Make sure that the discharged air will not be sucked back into the evaporator again.
Provide enough space to allow access to temperature controller.
Wall mounted digital controller
The controller is originally fixed to the maintenance door of the machine, it is possible to install
it on a wall, with the casing provided. To do so:
•
Disconnect the machine from power supply and open the top panel.
•
Check the digital controller wire and unplug it (do not pull on the wire coming out of the
back of the controller!).
•
Take the controller out of the machine (by pushing it from the inside outwards).
•
Install the provided casing on a wall and install the controller inside the box..
•
Connect the controller (from the wall-mounted casing) to the machine with the extension
wire provided. Be sure that the extension wire enters the machine through the designated
holes and bushings.
Outlet air flow:
3 m (120 " )
Inlet air flow:
1 m (40 " )
- 39 -