Axis Q35-VE Serie Guide D'installation page 23

Adjust the camera angle
1
Lines on optic holder that indicate an increment in the tilt angle by 10°
2
Small lines on optic mount that indicate a pan increment of 3°
3
Lines on optic mount that indicate a pan increment of 15°
4
Lines on lens cover to help ensure camera is level
1. Pan, tilt and rotate the camera to cover the area under surveillance. It is possible to pan
360°, and tilt to an angle of 90°.
2. Pan and rotate the lens to adjust the image.
3. Use the two lines on the lens cover to ensure that the camera is level. To activate
levelling aid, press the function button. See Function Button on page 14.
Attach the dome cover
1. Make sure the rubber gasket sits securely in the dome cover when you attach the dome
cover to the unit casing.
2. Slip the grooves in the black shield, over the screws on either side of the camera's optic
holder.
3. If you are using a weather shield, attach the weather shield to the dome cover. Use the
two screws delivered with the weather shield.
4. Attach the dome cover to the unit casing with the Resistorx® key TR20.
5. Remove the protective film from the dome cover.
AXIS Q35-VE Series
23