Basic Configuration - Audio Pro LIVING LV22 Manuel D'utilisation

BASIC CONFIGURATION

1
Before connecting to a computer, see Mac or PC setup.
1. Connect the TXD200 transmitter to the computer.
2. Connect both LV22 speakers to 230V outlet.
3. Done! Play your music on your computer.
WIRELESS STATUS:
LED is blue on the speakers and transmitters if a wireless connection has been established.
LED is red on the speakers and transmitters if no wireless connection has been established.
LED is green on the speakers and transmitters if a paired wireless connection has been established.
Note:
- Make sure that the speaker(s) and the transmitter use the same House Code (channel 1, 2 or 3).
- If the speakers are in automatic standby mode, the LED will be red even if a wireless connection
has been established. This turns blue when the speakers receive an audio signal.
MAC SETUP
1. Connect the TXD200 transmitter to a free USB port.
2. Go to System Preferences and choose Sound under Hardware.
3. Click Output in the menu and choose "Audio Pro TXD200".
Done! You can now send audio signals from your computer.
PC SETUP
Please carry out the following setup before using music playing software (for example iTunes or Spotify).
1. Connect the TXD200 transmitter to a free USB port. Wait until the software has been installed.
(A message window will be displayed in the lower right hand corner when the sound device is ready to use.)
Done! You can now send audio signals from your computer.
For some PC computers (e.g. with the Windows 7 operating system) you may also need to perform
the following steps:
2. Click Start button, go to Control Panel and choose Sound & Sound devices.
3. Under playback of audio, choose "TXD200" as the default unit.
Done! You can now send audio signals from your computer.
6
2 3
PAIRED AND UNPAIRED MODE
Pairing protects your Audio Pro network from interference from other
nearby Audio Pro Wireless networks.
PAIRING YOUR LV22 SPEAKERS WITH THE TXD200 TRANSMITTER
1. Press and hold down the Pairing button on the transmitter for 2 sec-
onds. The LED starts to flash green.
2. Press and hold down the ZONE/PAIR button on the LV22 speaker for 3
seconds. (the button is located on the back of the speaker.) The LED starts
to flash green.
3. When the LEDs on the transmitter and the speaker(s) become a steady
green, the system is paired.
NOTE:
The Master Volume is disabled in paired mode. Use the A-B-C zone
volume controls instead
UNPAIRED MODE
The TXD200/LV-HUB transmitters work in unpaired mode with all Living
speakers. The LV22 works with the TX100 transmitter in unpaired mode.
UNPAIRING SPEAKERS:
To unpair a system (all the speakers in the same volume zone will be unpaired):
1. Disconnect the TXD200 from the power source.
2. While pressing the pairing button, reconnect the TXD200 to the power source and hold
down the pairing button for about 3 seconds. Release the button when the LED turns red/blue
3. Turn the LV22 speaker,off using the main switch on the rear panel. While turning the
speaker on again, hold the House Code button pressed down.
USE LV22 WITH LV-SUB FLAT SUBWOOFER
The LV22 can be used in two modes, SATELLITE or FULLRANGE.
FR
The satellite mode is adapted for use together with the Living LV-SUB
FLAT SUBWOOFER.
Push and hold down both the House Code and the Zone buttons for 3
SAT
seconds; SAT will appear on the display. Repeat the same procedure to
switch to fullrange. Repeat the procedure on both speakers.
Note: In satellite mode, frequencies under 80Hz are disregarded for
LV22 playback. When LV22 is used in satellite mode together with LV-
SUB, you can play at a considerably higher volume.
7