Long-term mode of operation is recommended for rooms that are affected by odours, mold, etc. to a
greater extent. After ozone production is complete, wait approximately 90 minutes for self-destruction of
ozone. Entry into the treated area only after elapse of this time to avoid any health risk. After ozonation the
air in the room is clean and fresh.
The device must not come into contact with liquids. A device that got wet should never be
used. In this case, contact the manufacturer.
5. Precautions and notes on ozone application
Close windows, doors, and if they do not close tightly, seal the cracks. For example with duct
tape. After starting the treatment, leave the room, close the door to prevent leakage of ozone
from the room. Before leaving the room, make sure that there are no people or pets inside.
It is important that during the process of production and destruction of active oxygen, no
one enters the room. If entry into the room is necessary, this could be possible only if the
concentration of ozone in the room does not cause any health problems (see Annex).
Ozone is a toxic gas. Never breathe ozone at the outlet of the air stream from the device!
Fulfil the safety precautions applicable to electrical equipment! Avoid electric shock. Never
try to break into the device, never repair it yourself. During operation, the device must not
be covered and not be carried.
User manual
LIFETECH s.r.o.
17 / 36