Operation And Handling; Before First Use; Operation - Caso Germany SJW 400 Manuel D'instructions D'origine

15 Operation and Handling

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
Warning
► Do not leave the device unsupervised when it is in operation, so that you can intervene
quickly in the event of dangers.

15.1 Before first use

Clean the device, see "cleaning".

15.2 Operation

Attention
► Do not open the cover of juicer jug during using. In case power supply is on, do not put
hand or any object into the device or feeding port, otherwise harmful accident may
occur or the device may be damaged.
1. Connect the power, after you properly installed the device.
2. Prepare the ingredients.
Warning
► Do not touch the power cord with wet hands. It may cause electrical shock, short-circuit
or fire.
► Check the safety of the wall outlet.
3. Press the ON(I) button to operate.
4. If the juicer stops during operation: Switch the button O position then press and hold the
REV(II) button until the ingredients become dislodged. Repeat REV(II)-O-ON(I) if
needed.
ON(I): Pulls down the food
O: Stops the operation
REV(II): Pushes the food back up
Please note
► The REV(II) button only works while holding down the switch.
► Switch off (O) ensuring that the juicer comes to a complete stop. Then press REV(II).
► Hold the REV(II) button for 2-3 seconds and release. Repeat as needed. Let the juicer
stop completely before using the REV(II) button to prevent malfunction.
► If the juicer does not work after these steps, disassemble and clean the parts before
operating the juicer again.
5. Insert the prepared ingredients one piece at a time.
Please note
► After inserting ingredients, use the pusher when it is necessary. Too much use of the
pusher may affect the juice quality. Intermittently use the pusher for soft ingredients like
Caso Entsafter „Whole Slow Juicer" SJW 400 38