Nicheless Led Light - Jandy Pro Series Nicheless LED Underwater Light Manuel Du Propriétaire

Page 4
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION, which
could result in serious injury or death.
Nicheless LED Lights are only available for 12-volt AC power. For
supply connection, use only an isolating low voltage power supply with
ungrounded output, evaluated and listed by a NRTL for swimming pool
use.
Section 2.
Risk of Electrical Shock or Electrocution.
must be installed by a licensed or certified electrician or a qualified pool
serviceman in accordance with the National Electrical Code
Electrical Code, in Canada) and all applicable local codes and
ordinances. Improper installation will create an electrical hazard, which
could result in death or serious injury to pool or spa users, installers or
others due to electrical shock, and may also cause damage to property.
Always disconnect the power to the light at the circuit breaker before
installing or servicing the light. Failure to do so could result in death or
serious injury to serviceman, pool or spa users or others due to electrical
shock.
Use the chart below to determine the appropriate pipe length for your
installation.
JLU4C9W
JLUW9W
JLU4C20W
JLUW20W
JLU4C30W
JLUW30W
All products listed above come in a variety of cord lengths.
NOTE: The lights are servicable - do not remove the enclosure or
cord from the conduit. No seperate ground or bonding wire is required
for the JLU4C9W, JLUW9W, JLU4C20W, JLUW20W, JLUW30W or
JLU4C30W low voltage lights which do not have any exposed metal.
ENGLISH
WARNING
Installing the Jandy Pro Series

Nicheless LED Light

WARNING
WATTS
Typical cord lengths are 50, 100, & 150 feet.
Nicheless Underwater LED Lights | Owner's Manual
The Jandy
This underwater light
MINIMUM LENGTH
FOR 1.5" PIPE
9W
9W
20W
20W
30W
30W
Pro Series
®
(Canadian
®
3"
3"
9"
9"
14"
14"