Onda V-11 Manuel D'utilisation page 36

EN
5. Replace W lamp
The Tungsten lamp is equipped with a blue-grey silicon coating by manufacturer. This
coating is only a transport safety device. It can be removed with the first exchange of
lamp.
Pull out the defected W lamp and draw on the cotton glove. Insert the new W lamp as deep
as possible on the lamp seat. Be sure to keep the filament in the same direction as the old
one face.
6. Adjust the position of the W lamp
Switch on the power(the Switch Mirror should be placed to the position as indicates).
Observe the entrance facular, and it should in the center of the entrance hole. If the facular
deviate to Left or Right, then loosen the two screws and move the lamp seat to Left or Right
until it focus on the center of the slot. Then fix the screws.
Right
position
Visible models
34
Switching
mirror
UV/Visible models