Signature Kitchen Suite SKSDW2401S Mode D'emploi page 20

20 INSTALLATION
4
Insert the strain relief
through the hole in the junction box. Tighten the
ring nut to secure them in place.
Pair the white, black, and green wires to the
5
matching colored wires from the dishwasher.
Then twist on the provided wire nuts
connect the corresponding wires.
6
Wrap electrical tape
7 Fold the connected wires back into the junction
box and screw on the junction box cover.
and the electrical cable
tightly to
around each connection.
WARNING
Verify that the black wire is hot (120 V). If not,
or if you are unsure of the power supply, have it
checked by a licensed electrician.
CAUTION
Do not leave stripped wire exposed. Trim
stripped wire to fit completely inside wire nuts.